• VM 7700 Junior
    • VM 7700 Junior
    • VM 7700 Junior
    • VM 7700 Junior

    VM 7700 Junior

    We do not sell products factory direct or quote prices from the factory. You do have to go through a dealer to purchase product. We have several dealers located in almost every major hockey market. It is best, if possible, to be fitted to ensure proper product sizing and selection. This is best done at your local retailer.

    Click here to view a list of our authorized dealers.

    Any products that require repair under warranty should be returned through the retailer that the product was purchased from. We believe in the importance of satisfying our customers by manufacturing quality products. We, however, must be the sole judge in the matter of returns under warranty and we must have the product in hand to make an appropriate determination.

    Your equipment will wear much better if allowed to thoroughly dry between uses. Wet materials are more subject to abrasive type wear. Equipment should be air dried at room temperature. DO NOT use heat to dry equipment as this can cause premature, unseen damage to the surface materials and internal padding which will accelerate wear.

    Washing

    The goaltender’s mask must be inspected frequently for any visible damage. If the shell of the mask is chipped, cracked or if any of the internal padding is ripped or unglued, the mask should not be used as the protection may be reduced. If the wire cage has any broken welds, bent wires or other defects, it should be replaced before further use. The mask should not be altered in any way. Under no circumstances should the mask be painted other than by a factory-authorized painter. Do not drill holes, sand, paint, cut heat, or use solvents or any type of tape or stickers on the mask. Do not install a replacement cage or other components that are not intended to fit the specific model mask. Any alteration of the mask voids the warranty, along with any and all certification, and could potentially cause or contribute to injury to the user.

    The exterior shell should be cleaned with a damp non-abrasive cloth and mild dishwashing soap, if needed. The interior foam components can also be wiped down with a damp cloth. The sweatband can be machine laundered and dried. Replacement sweatbands are available. Never under any circumstances, use any chemicals or solvents to clean the mask.